Concrete Technology Part 1

January 21, 2020

Print Friendly, PDF & Email
1. Strength of commonly used concrete for constructing low rise residential buildings is
2. The setting time of cement is the governing factor for
3. Tensile strength of concrete is approximately______________of the compressive strength of concrete.
4. The strength of concrete using air entraining cement gets reduced by
5. The aggregate is said to be elongated when
6. As the cube size increases, the strength of concrete
7. Approximate value of shrinkage strain in concrete is
8. The ratio of 7 days and 28 days cube strength is
9. Strength of concrete increases with
10. Tensile strength of concrete is measured by
11. The resistance of an aggregate to wear is known as
12. The degree of grinding of cement is called
13. Workability of concrete is directly proportional to
14. According to IS: 269-1976, the requirement of an ordinary Portland cement is that
15. The chemical reaction between cement and water is
16. Increase in moisture content in concrete
17. The strength of concrete after one year as compared to 28 days strength is about
18. The fineness of cement is measured in terms of
19. The removal of excess air after placing concrete helps in increasing the strength of concrete by
20. The property of the ingredients to separate from each other while placing the concrete is called
21. A concrete cube of 15 cm and a cylinder of 150 mm diameter and 300 mm height are tested for compressive strength, the strength of the cube compared to cylinder will be
22. Modulus of rupture of concrete gives
23. Too much fineness of cement
24. The compressive strength of an ordinary Portland cement (1:3 cement mortar cube) after 7 days test should not be less than
25. According to IS 456, under normal circumstances, the maximum cement content in kg/cum (including fly ash and slag) allowed
26. The resistance of an aggregate to the effect of hydration of cement and weather is called
27. The cement concrete, from which entrained air and excess water are removed after placing it in position, is called
28. The binding material in the mortar is also called   [ SSC JE 2019]
29. The property of fresh concrete, in which the water in the mix tends to rise to the surface while placing and compacting, is called
30. Workability of concrete is inversely proportional to
31. The phenomenon by virtue of which the cement does not undergo large change in volume when treated with water is known as
32. The cement, widely used in retaining walls is
33. Which of the following cement is expected to have the highest compressive strength after 3 days?
34. The percentage of water for making a cement paste of normal consistency varies from
35. The failure strain of concrete under direct compression and under flexure are respectively

 

VideRime

A Demrot is the founder of VideRime Online Learning, a leading engineering website. He did his BE Civil and M.Tech Structure from RGPV University, Bhopal and has been working as an Assistant Professor in a reputed college.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Login Now
*
*
Forgot Password
 
VideRime Registration Form
*
*
*
*
*
*
    Strength: Very Weak