Questions

Filter:AllOpenResolvedClosedUnanswered
The ratio of the breadth to effective depth of a beam is kept
OpenVideRime asked 4 years ago • ,
188 views0 answers0 votes
The thickness of the flange of Tee beam of a ribbed slab is assumed as
OpenVideRime asked 4 years ago • ,
187 views0 answers0 votes
If the ratio of the span to the overall depth does not exceed 10, the stiffness of the beam will ordinarily be satisfactory in case of a
OpenVideRime asked 4 years ago • ,
202 views0 answers0 votes
In a doubly reinforced beam if c and t are stresses in concrete and tension reinforcement, d is the effective depth and n is depth of critical neutral axis, the following relationship holds good
OpenVideRime asked 4 years ago • ,
222 views0 answers0 votes
In a singly reinforced beam, the effective depth is measured from its compression edge to
OpenVideRime asked 4 years ago • ,
174 views0 answers0 votes
Minimum spacing between horizontal parallel reinforcement of the same size should not be less than
OpenVideRime asked 4 years ago • ,
231 views0 answers0 votes
If the depth of actual neutral axis of a doubly reinforced beam
OpenVideRime asked 4 years ago • ,
214 views0 answers0 votes
The moment of the couple set up in a section of a beam by the longitudinal compressive and tensile force is known as
OpenVideRime asked 4 years ago • ,
183 views0 answers0 votes
For initial estimate for a beam design, the width is assumed
OpenVideRime asked 4 years ago • ,
174 views0 answers0 votes
An intermediate T-beam reinforced with two layers of tensile steel with clear cover 13 cm encasted with the floor for a hall 12 meters by 7 meters, is spaced at 3 meters from adjoining beams and if the width of the beam is 20 cm, the breadth of the flange is
OpenVideRime asked 4 years ago • ,
218 views0 answers0 votes
1…7879808182…469