Questions

Filter:AllOpenResolvedClosedUnanswered
This is used to indicate that a surface is to be machined:
OpenVideRime asked 5 years ago • 
212 views0 answers0 votes
This is how axonometric, oblique, and perspective sketches show objects:
OpenVideRime asked 5 years ago • 
256 views0 answers0 votes
In the section view, the areas that would have been in actual contact with the cutting plane are shown with:
OpenVideRime asked 5 years ago • 
279 views0 answers0 votes
Placement of dimensions on a drawing is controlled by ________.
OpenVideRime asked 5 years ago • 
204 views0 answers0 votes
When designing a home for a client, one of the most important pre-design considerations that an architect needs to address is ______________.
OpenVideRime asked 5 years ago • 
471 views0 answers0 votes
In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
OpenVideRime asked 5 years ago • 
205 views0 answers1 votes
In offset sections, offsets or bends in the cutting plane are all:
OpenVideRime asked 5 years ago • 
217 views0 answers0 votes
These units are based on inch-foot and yard measurements:
OpenVideRime asked 5 years ago • 
234 views0 answers0 votes
The condition of a part when it contains the least amount of material is referred to as ________.
OpenVideRime asked 5 years ago • 
216 views0 answers0 votes
As the size of the component increases, the endurance limit of the component
AnsweredVideRime asked 5 years ago • 
4165 views1 answers0 votes
1…231232233234235…469
Login Now
*
*
Forgot Password
 
VideRime Registration Form
*
*
*
*
*
*
    Strength: Very Weak