Questions

Filter:AllOpenResolvedClosedUnanswered
The endurance limit of the component can be increased by
AnsweredVideRime asked 5 years ago • 
3682 views1 answers-4 votes
Some of the common terms used to describe technical drawing include:
OpenVideRime asked 5 years ago • 
297 views0 answers0 votes
This type of solid is formed by sweeping a shape along a linear path:
OpenVideRime asked 5 years ago • 
250 views0 answers0 votes
An advantage of this type of view is that each view shows the object all the way through as if it were transparent:
OpenVideRime asked 5 years ago • 
463 views0 answers1 votes
An engineer’s scale would be used to measure lines on a drawing where the scale factor reads ________.
OpenVideRime asked 5 years ago • 
209 views0 answers0 votes
This is the total amount that the feature on the actual part is allowed to vary from what is specified by the dimension:
OpenVideRime asked 5 years ago • 
334 views0 answers0 votes
In oblique sketches, the most commonly used angles for receding lines are:
OpenVideRime asked 5 years ago • 
280 views0 answers0 votes
The lines used to create the auxiliary view should appear as ________ in the finished view.
OpenVideRime asked 5 years ago • 
184 views0 answers0 votes
This is the plane upon which the top view is projected:
OpenVideRime asked 5 years ago • 
191 views0 answers0 votes
A civil engineer working on a bridge design would probably rely on his ________ scale for checking printed drawings.
OpenVideRime asked 5 years ago • 
345 views0 answers0 votes
1…232233234235236…469