Question Category: RCC

Questions › Category: RCC
Filter:AllOpenResolvedClosedUnanswered
If the area of tension reinforcement provided is less than that required for a balanced section, then the RCC beam is called
OpenVideRime asked 3 years ago • ,
91 views0 answers0 votes
As per IS 456-2000, in the absence of test data, the approximate value of the total strain for design may be taken as
OpenVideRime asked 3 years ago • ,
110 views0 answers0 votes
As per IS:456, splitting tensile strength (fct) of concrete may be estimated from compressive strength as
OpenVideRime asked 3 years ago • ,
89 views0 answers0 votes
In a singly reinforced beam, if the permissible stress in concrete reaches earlier than the permissible stress in steel, the beam section is called
OpenVideRime asked 3 years ago • ,
84 views0 answers0 votes
As per IS: 456-2000, the organic content of water used for making concrete should not be more than
OpenVideRime asked 3 years ago • ,
137 views0 answers0 votes
The modulus of elasticity of concrete in N/mm2 can be assumed as follows where fck is the characteristic cube compressive strength of concrete in N/mm2
OpenVideRime asked 3 years ago • ,
87 views0 answers0 votes
The characteristic strength of concrete is defined as that compressive strength below which NOT more than
OpenVideRime asked 3 years ago • ,
84 views0 answers0 votes
Minimum grade of concrete for moderate environmental exposure condition should be
OpenVideRime asked 3 years ago • ,
87 views0 answers0 votes
The modulus of rupture of concrete gives
OpenVideRime asked 3 years ago • ,
93 views0 answers0 votes
The tensile strength of concrete in flexure as per IS:456 is
OpenVideRime asked 3 years ago • ,
84 views0 answers0 votes
1…272829303132