Questions

Filter:AllOpenResolvedClosedUnanswered
The ________ tool on the Dimension tool bar will place several dimensions at one time by using a selection box placed over several part features.
OpenVideRime asked 5 years ago • 
215 views0 answers0 votes
These items typically are not used in new designs, but are still common in high-power amplifiers:
OpenVideRime asked 5 years ago • 
163 views0 answers0 votes
These types of projectors converge at a vanishing point:
OpenVideRime asked 5 years ago • 
168 views0 answers0 votes
Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing?
OpenVideRime asked 5 years ago • 
265 views0 answers0 votes
Schematic and single-line diagrams should be arranged so that signal or transmission path from input to output proceeds in this fashion:
OpenVideRime asked 5 years ago • 
300 views0 answers0 votes
Three dimensional models are often used in the design process to ________.
OpenVideRime asked 5 years ago • 
194 views0 answers0 votes
A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
OpenVideRime asked 5 years ago • 
604 views0 answers-1 votes
In this type of dimensioning, allowance must be made for bends:
OpenVideRime asked 5 years ago • 
209 views0 answers0 votes
A round is a rounded surface on the ________ corner of a part.
OpenVideRime asked 5 years ago • 
218 views0 answers0 votes
On typical electronic diagrams, these items need not be shown unless they are needed for clarification:
OpenVideRime asked 5 years ago • 
244 views0 answers0 votes
1…235236237238239…469