Questions

Filter:AllOpenResolvedClosedUnanswered
The ____________ dimension tool will place the length of an angled line.
OpenVideRime asked 5 years ago • 
352 views0 answers0 votes
A ___________ is the person responsible for verifying that the drawings in a project set are free of mistakes.
OpenVideRime asked 5 years ago • 
267 views0 answers0 votes
The principle reason for using an auxiliary view is ________.
OpenVideRime asked 5 years ago • 
527 views0 answers0 votes
The top, front, and bottom views align in this manner:
OpenVideRime asked 5 years ago • 
370 views0 answers0 votes
Several of the tools used in traditional drafting include the following:
OpenVideRime asked 5 years ago • 
289 views0 answers0 votes
This is a thin solid line directing attention to a note or dimension and starting with an arrowhead or dot:
OpenVideRime asked 5 years ago • 
225 views0 answers0 votes
This type of solid has a polygon for a base and triangular lateral faces that intersect at a vertex:
OpenVideRime asked 5 years ago • 
458 views0 answers0 votes
When using the descriptive geometry method to create an auxiliary view the drafter should _________.
OpenVideRime asked 5 years ago • 
257 views0 answers0 votes
Referring to the fractional inches to decimal inches to millimeter conversion chart on page 55 what is the equivalent mm measurement of 3/16 inch.
OpenVideRime asked 5 years ago • 
231 views0 answers0 votes
This line pattern is composed of three dashes, one long dash on each end with a short dash in the middle:
OpenVideRime asked 5 years ago • 
497 views0 answers-2 votes
1…234235236237238…469
Login Now
*
*
Forgot Password
 
VideRime Registration Form
*
*
*
*
*
*
    Strength: Very Weak