Question Category: Mechanical Engineering

Questions › Category: Mechanical Engineering
Filter:AllOpenResolvedClosedUnanswered
The Offset tool should only be used for placing _________ in an isometric drawing.
OpenVideRime asked 5 years ago • 
340 views0 answers0 votes
When lettering a CAD drawing, for clarity you should limit the number of fonts to:
OpenVideRime asked 5 years ago • 
329 views0 answers0 votes
In order to convert fractional inches into decimal inches __________.
OpenVideRime asked 5 years ago • 
335 views0 answers0 votes
The text height for room names should be set to ________for a drawing that will be plotted to a scale of ¼” = 1′-0″.
OpenVideRime asked 5 years ago • 
370 views0 answers0 votes
A cylinder can be created by drawing a rectangular shape then the ________ tool.
OpenVideRime asked 5 years ago • 
320 views0 answers0 votes
Before starting an isometric drawing in Auto-CAD the drafter needs to ________.
OpenVideRime asked 5 years ago • 
344 views0 answers0 votes
A line drawn with a long section, short dash, and another long section is a __________.
OpenVideRime asked 5 years ago • 
535 views0 answers2 votes
Generally, the units used on an architectural drawing are set to __________.
OpenVideRime asked 5 years ago • 
345 views0 answers0 votes
This type of projection is when projectors are parallel to each other, but are at an angle other than 90 degrees to the plane of projection:
OpenVideRime asked 5 years ago • 
289 views0 answers0 votes
The clutch used in trucks is
OpenVideRime asked 5 years ago • 
1402 views0 answers-7 votes
1…119120121122123…187