Question Category: Mechanical Engineering

Questions › Category: Mechanical Engineering
Filter:AllOpenResolvedClosedUnanswered
In case of multi-plate clutch if n1 is number of disks on driving shaft and n2 is the number of disks on driven shaft, then the number of pairs of contacting surfaces is given by
AnsweredVideRime asked 5 years ago • 
1555 views1 answers-1 votes
The surface finish factor for a highly polished component is
AnsweredVideRime asked 5 years ago • 
2816 views1 answers-2 votes
The friction radius for new clutch compared to worn out clutch will be
AnsweredVideRime asked 5 years ago • 
1987 views1 answers-2 votes
In case of cone clutch, a relatively small axial force can transmit a given torque, if the semi-cone angle is
AnsweredVideRime asked 5 years ago • 
2228 views1 answers-2 votes
The friction moment in a clutch with uniform wear as compared to friction moment with uniform pressure is
AnsweredVideRime asked 5 years ago • 
1157 views1 answers1 votes
This type of surface may be a plane, a single curved surface, or a warped surface:
OpenVideRime asked 5 years ago • 
437 views0 answers0 votes
CAD programs which incorporate parametric modeling utilize a system in which the dimensions control the ________.
OpenVideRime asked 5 years ago • 
366 views0 answers0 votes
The Press-Pull tool will ________ the face of a solid model in the direction it faces.
OpenVideRime asked 5 years ago • 
171 views0 answers0 votes
These plans, made by the steel fabricator, are assembly drawings for the steel structure:
OpenVideRime asked 5 years ago • 
209 views0 answers0 votes
These are special installations of stone or concrete marking the locations of points accurately determined by precise surveying:
OpenVideRime asked 5 years ago • 
228 views0 answers0 votes
1…112113114115116…187