Question Category: Civil Engineering

Questions › Category: Civil Engineering
Filter:AllOpenResolvedClosedUnanswered
The maximum slenderness ratio of a compression member carrying both dead and superimposed load is
OpenVideRime asked 5 years ago • 
414 views0 answers-1 votes
The maximum slenderness ratio of a compression member carrying both dead and superimposed load is
OpenVideRime asked 5 years ago • 
438 views0 answers0 votes
Slenderness ratio of the lacing bar for compression member should not exceed
OpenVideRime asked 5 years ago • 
277 views0 answers-1 votes
In order to determine the gross-sectional area of a tension member consisting of two angle sections, the allowance for holes is made as
OpenVideRime asked 5 years ago • 
641 views0 answers0 votes
Net sectional area of a tension member is equal to
OpenVideRime asked 5 years ago • 
232 views0 answers0 votes
A tension member subjected to axial tension is designed on the basis of its
OpenVideRime asked 5 years ago • 
689 views0 answers0 votes
In a tension member, the failure will occur in zig-zag line if the gauge distance is _______________pitch of rivets.
OpenVideRime asked 5 years ago • 
408 views0 answers-1 votes
The net sectional area of a tension member is equal to
OpenVideRime asked 5 years ago • 
520 views0 answers-1 votes
Minimum percentage of tension steel in an RCC beam for Fe 500 steel is
OpenVideRime asked 5 years ago • 
617 views0 answers1 votes
The limiting slenderness ratio for the main members of a steel bridge is 
OpenVideRime asked 5 years ago • 
200 views0 answers0 votes
1…131132133134135…194