Questions › Category: Civil EngineeringFilter:AllOpenResolvedClosedUnansweredSort byViewsAnswersVotesWhat shall be the maximum area of reinforcement (i) in compression and (ii) in tension to be provided in an RC beam, respectively, as per IS: 456?OpenVideRime asked 4 years ago • Civil Engineering375 views0 answers0 votesIn the reinforced concrete slab, the spacing between main reinforcement should not exceedOpenVideRime asked 4 years ago • Civil Engineering771 views0 answers0 votesIn doubly reinforced rectangular beam, the allowable stress in compression steel isOpenVideRime asked 4 years ago • Civil Engineering1808 views0 answers0 votesIn case of 2-way slab, the limiting deflection of the slab isOpenVideRime asked 4 years ago • Civil Engineering1556 views0 answers1 votesWhich one of the following statements about the percentage of tensile steel required to produce a balanced reinforced concrete section is correct? The required percentage of steelOpenVideRime asked 4 years ago • Civil Engineering1274 views0 answers-1 votesWhat is the modular ratio to be used in the analysis of RC beam using working stress method if the grade of concrete is M 20?OpenVideRime asked 4 years ago • Civil Engineering1009 views0 answers0 votesWhat is the adoptable maximum spacing between vertical stirrups in a RCC beam of a rectangular crosssection having an effective depth of 300 mmOpenVideRime asked 4 years ago • Civil Engineering469 views0 answers0 votesConsider the following statements. In an under-reinforced concrete beam, 1) Actual depth of neutral axis is less than the critical depth of neutral axis 2) Concrete reaches ultimate stress prior to steel reaching the ultimate stress 3) Moment of resistance is less than that of balanced sections. 4) Lever arm of resisting couple is less than of balanced section Which of these statements is/are correct?OpenVideRime asked 4 years ago • Civil Engineering2286 views0 answers1 votesThe span to depth ratio limit is specified in IS: 456-2000 for the reinforced concrete beam, in order to ensure that theOpenVideRime asked 4 years ago • Civil Engineering1148 views0 answers0 votesAs per the provision of IS: 456-2000, in the limit state method for design of beams, the limiting value of the depth of neutral axis in a reinforced concrete beam of effective depth `d’ is given asOpenVideRime asked 4 years ago • Civil Engineering475 views0 answers1 votes
VideRime