Question Category: Civil Engineering

Questions › Category: Civil Engineering
Filter:AllOpenResolvedClosedUnanswered
A singly reinforced balanced section designed by limit state method will have 1. Lesser depth compared to designed by working stress method 2. Higher value of steel compared to designed by working stress method 3. Lower cost compared to designed by working stress method Which of these statements is/are correct?
OpenVideRime asked 6 years ago • 
1376 views0 answers1 votes
If the permissible stress in steel is 500 MPa, then working stress in bending compression would be taken as
OpenVideRime asked 6 years ago • 
306 views0 answers0 votes
Modular ratio for M30 grade of concrete is
AnsweredVideRime asked 6 years ago • 
1960 views1 answers0 votes
Flexure collapse in over reinforced beam is due to
AnsweredVideRime asked 6 years ago • 
2734 views1 answers0 votes
In working stress method, the stresses used for design purpose are
OpenVideRime asked 6 years ago • 
753 views0 answers0 votes
Clay is an example of
AnsweredVideRime asked 6 years ago • 
1104 views1 answers1 votes
Calculate the evaporation (mm) from a pond, if the pan evaporation is 45 mm, the pan coefficient is 0.70
AnsweredVideRime asked 6 years ago • 
857 views1 answers-2 votes
Which of the following is a non-recording raingauge?
AnsweredVideRime asked 6 years ago • 
1136 views1 answers0 votes
The hoop stresses are acting across the
AnsweredVideRime asked 6 years ago • 
1290 views1 answers0 votes
The specific gravity of sandy soils is
AnsweredVideRime asked 6 years ago • 
493 views1 answers0 votes
1…184185186187188…194