Questions

Filter:AllOpenResolvedClosedUnanswered
The limiting slenderness ratio for the main members of a steel bridge is 
OpenVideRime asked 6 years ago • 
250 views0 answers0 votes
In the context of ultimate load theory for steel, stress-strain curve for steel is idealized as
OpenVideRime asked 6 years ago • 
255 views0 answers0 votes
Working stress for structural steel in tension is of the order of
OpenVideRime asked 6 years ago • 
482 views0 answers0 votes
The weakest plane in a fillet weld is
OpenVideRime asked 6 years ago • 
404 views0 answers0 votes
A butt weld is specified by
OpenVideRime asked 6 years ago • 
694 views0 answers-1 votes
The throat in a fillet weld is
OpenVideRime asked 6 years ago • 
277 views0 answers0 votes
The effective length of fillet weld should not be less than 
OpenVideRime asked 6 years ago • 
459 views0 answers-2 votes
The diameter of rivet hole in tension members using rivet of diameter more than 24 mm will be equal to
OpenVideRime asked 6 years ago • 
808 views0 answers0 votes
Which one of the following is the mode of failure in a fillet weld material?
OpenVideRime asked 6 years ago • 
670 views0 answers0 votes
Fillet weld is not recommended if the angle between fusion faces is i) less than 45° ii) greater than 120° iii) less than 60° iv) greater than 145°
OpenVideRime asked 6 years ago • 
707 views0 answers0 votes
1…379380381382383…470
Login Now
*
*
Forgot Password
 
VideRime Registration Form
*
*
*
*
*
*
    Strength: Very Weak