Questions

Filter:AllOpenResolvedClosedUnanswered
For obtaining high COP, the pressure range of compressor should be
OpenVideRime asked 5 years ago • 
269 views0 answers1 votes
The boiling point of ammonia is
OpenVideRime asked 5 years ago • 
252 views0 answers0 votes
Freon group of refrigerants are
OpenVideRime asked 5 years ago • 
331 views0 answers0 votes
A thermostatic expansion valve in a refrigeration system
OpenVideRime asked 5 years ago • 
216 views0 answers0 votes
In a refrigeration system, heat absorbed in comparison to heat rejected is
OpenVideRime asked 5 years ago • 
174 views0 answers0 votes
Most thermostatic expansion valves are set for a superheat of
OpenVideRime asked 5 years ago • 
203 views0 answers0 votes
The change in evaporator temperature in a refrigeration cycle, as compared to change in condenser temperature, influences the value of C.O.P.
OpenVideRime asked 5 years ago • 
586 views0 answers1 votes
The atmospheric air at dry bulb temperature of 15°C enters a heating coil maintained at 40°C. The air leaves the heating coil at 25°C. The bypass factor of the heating coil is
OpenVideRime asked 5 years ago • 
440 views0 answers0 votes
The general rule for rating refrigeration systems (excepting for CO₂ system) is to approximate following h.p. per ton of refrigeration
OpenVideRime asked 5 years ago • 
156 views0 answers0 votes
When the temperature of the surrounding is higher than the temperature of the body, then the heat loss by convection from the body to the surrounding will be
OpenVideRime asked 5 years ago • 
203 views0 answers0 votes
1…265266267268269…469