Questions

Filter:AllOpenResolvedClosedUnanswered
Once a drawing is determined to be complete, the title block is used to document the change from:
OpenVideRime asked 5 years ago • 
181 views0 answers0 votes
In working drawings, these show all necessary information not given directly on the drawing with its dimensions and notes:
OpenVideRime asked 5 years ago • 
303 views0 answers1 votes
Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________.
OpenVideRime asked 5 years ago • 
246 views0 answers0 votes
This is a flat or rounded tab protruding from a surface, usually to provide a method for attachment:
OpenVideRime asked 5 years ago • 
303 views0 answers0 votes
When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line.
OpenVideRime asked 5 years ago • 
408 views0 answers0 votes
In order to create one solid model from two or more separate solid shapes the drafter will need to position them and then ________.
OpenVideRime asked 5 years ago • 
349 views0 answers0 votes
 The bounding box method for setting up an isometric drawing helps the drafter ________.
OpenVideRime asked 5 years ago • 
245 views0 answers0 votes
There are two main types of projection:
OpenVideRime asked 5 years ago • 
358 views0 answers0 votes
Once the architect has finalized the house plans with the client any changes to the design requested by the client will require a ________.
OpenVideRime asked 5 years ago • 
181 views0 answers0 votes
Traditional drafters need to be able to create several different line widths because ________.
OpenVideRime asked 5 years ago • 
315 views0 answers0 votes
1…255256257258259…469