Questions

Filter:AllOpenResolvedClosedUnanswered
Circular shapes appear in this fashion when viewed at an angle other than 90 degrees:
OpenVideRime asked 5 years ago • 
200 views0 answers0 votes
The View toolbar will position the view of the 3-D solid toward the ________.
OpenVideRime asked 5 years ago • 
213 views0 answers0 votes
This material is used in masonry construction, most commonly for ornamental facing:
OpenVideRime asked 5 years ago • 
157 views0 answers0 votes
These maps are used in planning installations of trees, shrubbery, drives, and other garden features:
OpenVideRime asked 5 years ago • 
274 views0 answers0 votes
The maximum and minimum sizes of a feature are identified by a ________ tolerance.
OpenVideRime asked 5 years ago • 
484 views0 answers0 votes
Perspective drawings are classified according to their number of these features:
OpenVideRime asked 5 years ago • 
273 views0 answers0 votes
EDM is the acronym for:
OpenVideRime asked 5 years ago • 
232 views0 answers0 votes
Welding drawings are a special type of this kind of drawing:
OpenVideRime asked 5 years ago • 
200 views0 answers0 votes
In oblique projection, important shapes should be in this position relative to the viewing plane:
OpenVideRime asked 5 years ago • 
129 views0 answers0 votes
In case of multi-disk clutches, oil is used,
AnsweredVideRime asked 5 years ago • 
3239 views1 answers-2 votes
1…251252253254255…469