Questions › Tag: Strength of MaterialsFilter:AllOpenResolvedClosedUnansweredSort byViewsAnswersVotesA beam of 6 m long, simply supported at its end is carrying a point load W at its mid span. If slope at the end is not to exceed 2°, then deflection at mid span will beOpenVideRime asked 4 years ago • Civil Engineering170 views0 answers0 votesA cantilever of length L carries a concentrated load w at the mid span. If the free end is supported on a rigid prop the reaction of the prop will beOpenVideRime asked 4 years ago • Civil Engineering1819 views0 answers0 votesA simply supported beam AB of span L carries two concentrated load W each at points L/3 from A and B. What is the shear force in the middle one third portion of beam.OpenVideRime asked 4 years ago • Civil Engineering3450 views0 answers-10 votesThe bending moment for a certain portion of the beam is constant. For that section, shear force would beOpenVideRime asked 4 years ago • Civil Engineering663 views0 answers-1 votesStrength of the beam depends onOpenVideRime asked 4 years ago • Civil Engineering768 views0 answers0 votesThe principal stresses σ1, σ2 and σ3 at a point respectively are 80 MPa, 30 MPa and -40 MPa. The maximum shear stress isOpenVideRime asked 4 years ago • Civil Engineering1007 views0 answers3 votesThe combined effect of external forces acting on a body is calledOpenVideRime asked 4 years ago • Civil Engineering4391 views1 answers-3 votesThe unit of Young’s modulus is same as that ofOpenVideRime asked 4 years ago • Civil Engineering743 views0 answers1 votesYoung’s modulus of a wire is defined as the stress which will increase the length of wire compared to its original length byAnsweredVideRime asked 4 years ago • Civil Engineering402 views1 answers0 votes