Question Tag: Strength of Materials

Questions › Tag: Strength of Materials
Filter:AllOpenResolvedClosedUnanswered
The most economical section of the shaft subjected to torsion is
OpenVideRime asked 5 years ago • 
1016 views0 answers-2 votes
The intensity of shear stress in a shaft subjected to torsion is maximum at
OpenVideRime asked 5 years ago • 
385 views0 answers0 votes
The type of stresses setup in a rotating shaft due to torsion are
OpenVideRime asked 5 years ago • 
460 views0 answers1 votes
The shear stress at the centre of a circular shaft under torsion is
OpenVideRime asked 5 years ago • 
300 views0 answers0 votes
If the bending moment is consistent there will be no______________ stresses
OpenVideRime asked 5 years ago • 
300 views0 answers-1 votes
Bending moment at supports in case of simply supported beam is always
OpenVideRime asked 5 years ago • 
698 views0 answers0 votes
In a cantilever, maximum deflection occurs, where
OpenVideRime asked 5 years ago • 
742 views0 answers0 votes
If load at the free end of the cantilever beam is gradually increased, failure will occur
OpenVideRime asked 5 years ago • 
328 views0 answers0 votes
The bending moment diagram for a simply supported beam loaded in its centre is
OpenVideRime asked 5 years ago • 
442 views0 answers0 votes
The ratio of maximum shear stress to hoop stress in a thin cylindrical pressure vessel is
OpenVideRime asked 5 years ago • 
2504 views0 answers-3 votes
123