Question Category: Mechanical Engineering

Questions › Category: Mechanical Engineering
Filter:AllOpenResolvedClosedUnanswered
The most common geometric form used in gears today is this
OpenVideRime asked 5 years ago • 
185 views0 answers0 votes
In order to set drawing limits for a ‘C’ size architectural drawing the drafter should set the limits to ________.
OpenVideRime asked 5 years ago • 
245 views0 answers0 votes
This is a conical-shaped recess around a hole, often used to receive a tapered screw head
OpenVideRime asked 5 years ago • 
373 views0 answers0 votes
A fillet is a rounded surface on the ________ corner of a part.
OpenVideRime asked 5 years ago • 
335 views0 answers0 votes
Once a drawing is determined to be complete, the title block is used to document the change from:
OpenVideRime asked 5 years ago • 
200 views0 answers0 votes
In working drawings, these show all necessary information not given directly on the drawing with its dimensions and notes:
OpenVideRime asked 5 years ago • 
332 views0 answers1 votes
Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________.
OpenVideRime asked 5 years ago • 
265 views0 answers0 votes
This is a flat or rounded tab protruding from a surface, usually to provide a method for attachment:
OpenVideRime asked 5 years ago • 
320 views0 answers0 votes
When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line.
OpenVideRime asked 5 years ago • 
440 views0 answers0 votes
In order to create one solid model from two or more separate solid shapes the drafter will need to position them and then ________.
OpenVideRime asked 5 years ago • 
374 views0 answers0 votes
1…117118119120121…187
Login Now
*
*
Forgot Password
 
VideRime Registration Form
*
*
*
*
*
*
    Strength: Very Weak