Question Category: Mechanical Engineering

Questions › Category: Mechanical Engineering
Filter:AllOpenResolvedClosedUnanswered
The Offset tool should only be used for placing _________ in an isometric drawing.
OpenVideRime asked 5 years ago • 
378 views0 answers0 votes
When lettering a CAD drawing, for clarity you should limit the number of fonts to:
OpenVideRime asked 5 years ago • 
366 views0 answers0 votes
In order to convert fractional inches into decimal inches __________.
OpenVideRime asked 5 years ago • 
372 views0 answers0 votes
The text height for room names should be set to ________for a drawing that will be plotted to a scale of ¼” = 1′-0″.
OpenVideRime asked 5 years ago • 
426 views0 answers0 votes
A cylinder can be created by drawing a rectangular shape then the ________ tool.
OpenVideRime asked 5 years ago • 
350 views0 answers0 votes
Before starting an isometric drawing in Auto-CAD the drafter needs to ________.
OpenVideRime asked 5 years ago • 
382 views0 answers0 votes
A line drawn with a long section, short dash, and another long section is a __________.
OpenVideRime asked 5 years ago • 
573 views0 answers2 votes
Generally, the units used on an architectural drawing are set to __________.
OpenVideRime asked 5 years ago • 
378 views0 answers0 votes
This type of projection is when projectors are parallel to each other, but are at an angle other than 90 degrees to the plane of projection:
OpenVideRime asked 5 years ago • 
330 views0 answers0 votes
The clutch used in trucks is
OpenVideRime asked 5 years ago • 
1453 views0 answers-7 votes
1…119120121122123…187
Login Now
*
*
Forgot Password
 
VideRime Registration Form
*
*
*
*
*
*
    Strength: Very Weak