Question Category: Civil Engineering

Questions › Category: Civil Engineering
Filter:AllOpenResolvedClosedUnanswered
Two cars are moving in the opposite direction with speeds 25m/s and 20 m/s respectively. If total reaction time is 2.5seconds and design coefficient of friction is 0.3, then
AnsweredVideRime asked 5 years ago • 
402 views1 answers0 votes
Red light is used as signal for stop as it is visible from greater distances than other colours because of its
AnsweredVideRime asked 5 years ago • 
336 views1 answers0 votes
A certain fixed amount from the gross rent or income is set aside annually to accumulate the cost of construction when the building life is over is called
AnsweredVideRime asked 5 years ago • 
631 views1 answers0 votes
Boiling water or adding lime in water will remove the hardness of water when it is due to
AnsweredVideRime asked 5 years ago • 
379 views1 answers0 votes
The maximum area of tension reinforcement in a rectangular beam shall not exceed_____________. ‘b’ is width and ‘D’ is overall depth and ‘d’ is effective depth
AnsweredVideRime asked 5 years ago • 
383 views1 answers0 votes
For a pipe of diameter 1m when running full, the hydraulic mean depth will be
AnsweredVideRime asked 5 years ago • 
451 views1 answers0 votes
Which of the following components of ordinary Portland cement is responsible for flash setting?
AnsweredVideRime asked 5 years ago • 
402 views1 answers0 votes
Which of the following decreases the Workability of Concrete?
AnsweredVideRime asked 5 years ago • 
589 views1 answers0 votes
In an open channel flow, for best efficiency of a rectangular section channel, ratio of bottom width to depth shall be
AnsweredVideRime asked 5 years ago • 
354 views1 answers0 votes
When paint is applied in three coats, the first coat is known as
AnsweredVideRime asked 5 years ago • 
546 views1 answers0 votes
1…151152153154155…194