Steel Structures MCQs Mock test Set-2

March 6, 2021

Print Friendly, PDF & Email
 33%

Page 1 of 3

1. Fillet weld is not recommended if the angle between fusion faces is

i) less than 45°

ii) greater than 120°

iii) less than 60°

iv) greater than 145°

2. The limiting slenderness ratio for the main members of a steel bridge is

3. The effective length of continuous compression members is adopted between ________________ times the distance between centres of intersection.

4. Two plates of 16mm and 14mm are joined by fillet, the maximum size of fillet weld may be

5. Minimum percentage of tension steel in an RCC beam for Fe 500 steel is

6. Which of the following is a best compression member section?

7. Working stress for structural steel in tension is of the order of

8. The throat in a fillet weld is

9. Effective length of the fillet weld is

10. In order to determine the gross-sectional area of a tension member consisting of two laced channels, the allowance for holes is made as


 

VideRime

A Demrot is the founder of VideRime Online Learning, a leading engineering website. He did his BE Civil and M.Tech Structure from RGPV University, Bhopal and has been working as an Assistant Professor in a reputed college.

Leave a Reply