Questions

Questions › Author "admin"
Filter:QuestionsSubscribes
Two plates of 16mm and 14mm are joined by fillet, the maximum size of fillet weld may be
OpenVideRime asked 5 years ago • 
1108 views0 answers0 votes
When the bolts are subjected to reversal of stresses, the most suitable type of bolt is
OpenVideRime asked 5 years ago • 
246 views0 answers0 votes
In a tension member, when one or more than one rivet hole is off the line, then the failure of plate depends upon
OpenVideRime asked 5 years ago • 
822 views0 answers-1 votes
As per IS code, the maximum pitch of rivets in compression flange (thickness ‘t’) of a built up beam is
OpenVideRime asked 5 years ago • 
379 views0 answers0 votes
A steel plate is 30 cm wide and 10 mm thick. A rivet of nominal diameter of 18 mm is driven. The net sectional area of plate is
OpenVideRime asked 5 years ago • 
439 views0 answers0 votes
The permissible stresses in rivets under wind load condition as per IS: 800 can be exceeded by about
OpenVideRime asked 5 years ago • 
467 views0 answers0 votes
The weight of 1 m2  of mild steel is approximately
OpenVideRime asked 5 years ago • 
231 views0 answers0 votes
The live loads
OpenVideRime asked 5 years ago • 
168 views0 answers0 votes
The dead loads
OpenVideRime asked 5 years ago • 
194 views0 answers0 votes
The main advantage of a steel member is that it
OpenVideRime asked 5 years ago • 
649 views0 answers-1 votes
1…371372373374375…461