Questions › Author "admin"Filter:QuestionsSubscribesSort byViewsAnswersVotesFor obtaining high COP, the pressure range of compressor should beOpenVideRime asked 5 years ago • Mechanical Engineering295 views0 answers1 votesThe boiling point of ammonia isOpenVideRime asked 5 years ago • Mechanical Engineering282 views0 answers0 votesFreon group of refrigerants areOpenVideRime asked 5 years ago • Mechanical Engineering360 views0 answers0 votesA thermostatic expansion valve in a refrigeration systemOpenVideRime asked 5 years ago • Mechanical Engineering243 views0 answers0 votesIn a refrigeration system, heat absorbed in comparison to heat rejected isOpenVideRime asked 5 years ago • Mechanical Engineering201 views0 answers0 votesMost thermostatic expansion valves are set for a superheat ofOpenVideRime asked 5 years ago • Mechanical Engineering227 views0 answers0 votesThe change in evaporator temperature in a refrigeration cycle, as compared to change in condenser temperature, influences the value of C.O.P.OpenVideRime asked 5 years ago • Mechanical Engineering628 views0 answers1 votesThe atmospheric air at dry bulb temperature of 15°C enters a heating coil maintained at 40°C. The air leaves the heating coil at 25°C. The bypass factor of the heating coil isOpenVideRime asked 5 years ago • Mechanical Engineering468 views0 answers0 votesThe general rule for rating refrigeration systems (excepting for CO₂ system) is to approximate following h.p. per ton of refrigerationOpenVideRime asked 5 years ago • Mechanical Engineering181 views0 answers0 votesWhen the temperature of the surrounding is higher than the temperature of the body, then the heat loss by convection from the body to the surrounding will beOpenVideRime asked 5 years ago • Mechanical Engineering230 views0 answers0 votesShare this Now with Friends: Share on WhatsApp (Opens in new window) WhatsApp Share on Telegram (Opens in new window) Telegram More