Question Category: Mechanical Engineering

Questions › Category: Mechanical Engineering
Filter:AllOpenResolvedClosedUnanswered
A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.
OpenVideRime asked 5 years ago • 
158 views0 answers0 votes
This is used to indicate that a surface is to be machined:
OpenVideRime asked 5 years ago • 
188 views0 answers0 votes
This is how axonometric, oblique, and perspective sketches show objects:
OpenVideRime asked 5 years ago • 
230 views0 answers0 votes
In the section view, the areas that would have been in actual contact with the cutting plane are shown with:
OpenVideRime asked 5 years ago • 
258 views0 answers0 votes
Placement of dimensions on a drawing is controlled by ________.
OpenVideRime asked 5 years ago • 
161 views0 answers0 votes
When designing a home for a client, one of the most important pre-design considerations that an architect needs to address is ______________.
OpenVideRime asked 5 years ago • 
440 views0 answers0 votes
In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
OpenVideRime asked 5 years ago • 
183 views0 answers1 votes
In offset sections, offsets or bends in the cutting plane are all:
OpenVideRime asked 5 years ago • 
188 views0 answers0 votes
These units are based on inch-foot and yard measurements:
OpenVideRime asked 5 years ago • 
195 views0 answers0 votes
The condition of a part when it contains the least amount of material is referred to as ________.
OpenVideRime asked 5 years ago • 
190 views0 answers0 votes
1…104105106107108…187