Question Category: Strength of Materials

Questions › Category: Strength of Materials
Filter:AllOpenResolvedClosedUnanswered
The ratio of longitudinal stress to strain within elastic limit is known as
OpenVideRime asked 4 years ago • ,
160 views0 answers0 votes
The ratio of hydrostatic stress to the volumetric strain within the elastic range is called
OpenVideRime asked 4 years ago • ,
182 views0 answers0 votes
Assuming the values of maximum deviation ∆P and ∆E to be 25% of the computed value of P and E respectively, the minimum value of the factor of safety is
OpenVideRime asked 4 years ago • ,
300 views0 answers0 votes
When a load is transferred through one surface to another surface in contact, the stress is known as
OpenVideRime asked 4 years ago • ,
158 views0 answers0 votes
A bar L meter long and having its area of cross-section A, is subjected to a gradually applied tensile load W. The strain energy stored in the bar is
OpenVideRime asked 4 years ago • ,
229 views0 answers0 votes
The load of 1960 N is raised at the end of a steel wire. The minimum diameter of the wire so that stress in the wire does not exceed 100N/mm2 is
OpenVideRime asked 4 years ago • ,
191 views0 answers0 votes
The ratio of shear stress and shear strain of an elastic material is
OpenVideRime asked 4 years ago • ,
173 views0 answers0 votes
A material is said to be perfectly elastic
OpenVideRime asked 4 years ago • ,
150 views0 answers0 votes
The forces acting normally on the cross section of a bar shown in the figure below introduce
OpenVideRime asked 4 years ago • ,
145 views0 answers0 votes
In a composite system subjected to temperature rise and with ends constrained to remain together, the component having lower value of coefficient of linear expansion will experience_____________
OpenVideRime asked 4 years ago • ,
310 views0 answers0 votes
1…1112131415…20