Question Category: RCC

Questions › Category: RCC
Filter:AllOpenResolvedClosedUnanswered
The width of the flange of T-beam, which may be considered to act effectively with the rib depends upon___________________
OpenVideRime asked 4 years ago • ,
187 views0 answers0 votes
The minimum thickness of the cover at the end of a reinforcing bar should not be less than twice the diameter of the bar subject to a minimum.
OpenVideRime asked 4 years ago • ,
201 views0 answers0 votes
Minimum spacing between horizontal parallel reinforcement of different sizes, should not be less than
OpenVideRime asked 4 years ago • ,
193 views0 answers0 votes
As the span of a bridge increases, the impact factor_______________
OpenVideRime asked 4 years ago • ,
206 views0 answers0 votes
Torsion resisting capacity of a given reinforced concrete section_______________
OpenVideRime asked 4 years ago • ,
226 views0 answers0 votes
The assumption made in the theory of reinforced cement concrete beam is that
OpenVideRime asked 4 years ago • ,
210 views0 answers0 votes
The final deflection due to all loads including the effects of temperature, creep and shrinkage and measured from as-cast level of supports of floors, roofs, and all other horizontal members should not exceed__________________
OpenVideRime asked 4 years ago • ,
234 views0 answers0 votes
A reinforced cantilever beam of span 4m has a cross-section of 150 x 500 mm. If checked for lateral stability and deflection, the beam will________________
OpenVideRime asked 4 years ago • ,
202 views0 answers0 votes
The side face reinforcement, if required in a T beam will be______________
OpenVideRime asked 4 years ago • ,
213 views0 answers0 votes
From limiting deflection point of view, use of high strength steel in RCC beam results in
OpenVideRime asked 4 years ago • ,
250 views0 answers0 votes
1…910111213…32
VideRime Online Learning