Question Category: Civil Engineering

Questions › Category: Civil Engineering
Filter:AllOpenResolvedClosedUnanswered
Two plates of 16mm and 14mm are joined by fillet, the maximum size of fillet weld may be
OpenVideRime asked 6 years ago • 
1203 views0 answers0 votes
When the bolts are subjected to reversal of stresses, the most suitable type of bolt is
OpenVideRime asked 6 years ago • 
293 views0 answers0 votes
In a tension member, when one or more than one rivet hole is off the line, then the failure of plate depends upon
OpenVideRime asked 6 years ago • 
871 views0 answers-1 votes
As per IS code, the maximum pitch of rivets in compression flange (thickness ‘t’) of a built up beam is
OpenVideRime asked 6 years ago • 
431 views0 answers0 votes
A steel plate is 30 cm wide and 10 mm thick. A rivet of nominal diameter of 18 mm is driven. The net sectional area of plate is
OpenVideRime asked 6 years ago • 
488 views0 answers0 votes
The permissible stresses in rivets under wind load condition as per IS: 800 can be exceeded by about
OpenVideRime asked 6 years ago • 
517 views0 answers0 votes
The weight of 1 m2  of mild steel is approximately
OpenVideRime asked 6 years ago • 
269 views0 answers0 votes
The live loads
OpenVideRime asked 6 years ago • 
237 views0 answers0 votes
The dead loads
OpenVideRime asked 6 years ago • 
244 views0 answers0 votes
The main advantage of a steel member is that it
OpenVideRime asked 6 years ago • 
692 views0 answers-1 votes
1…133134135136137…194
Login Now
*
*
Forgot Password
 
VideRime Registration Form
*
*
*
*
*
*
    Strength: Very Weak