Question Category: Civil Engineering

Questions › Category: Civil Engineering
Filter:AllOpenResolvedClosedUnanswered
The minimum percentage of shear reinforcement in R.C.C beams is_____________
OpenVideRime asked 4 years ago • ,
183 views0 answers0 votes
Shear span is defined as the zone where_____________
OpenVideRime asked 4 years ago • ,
165 views0 answers0 votes
Which one of the following statements is correct? Shear design for a prestresed concrete beam is based on elastic theory 
OpenVideRime asked 4 years ago • ,
161 views0 answers0 votes
Deep beams are designed for
OpenVideRime asked 4 years ago • ,
157 views0 answers0 votes
In a singly reinforced beam, if the concrete is stressed to its allowable limit earlier than steel the section is said to be
OpenVideRime asked 4 years ago • ,
163 views0 answers0 votes
If 𝜏v is the nominal shear stress, 𝜏c is design shear strength of concrete and 𝜏c,max is the maximum design shear strength of concrete, which of the following statement is correct?
OpenVideRime asked 4 years ago • ,
330 views0 answers0 votes
In an RCC section of effective depth ‘d’, if vertical stirrups are provided to resist shear, their maximum spacing measured along the axis of the member as per IS: 456-2000 should not exceed
OpenVideRime asked 4 years ago • ,
211 views0 answers0 votes
Diagonal tension in a reinforced concrete beam:
OpenVideRime asked 4 years ago • ,
138 views0 answers0 votes
The factored load at the limit state of collapse for DL + LL, DL + WL and DL + LL + WL combinations, according to IS: 456-2000 are respectively.
OpenVideRime asked 4 years ago • ,
186 views0 answers0 votes
In limit state of collapse against flexure, the maximum strain in tension reinforcement at failure shall not be less than
OpenVideRime asked 4 years ago • ,
149 views0 answers0 votes
1…2627282930…194